Hook up baseboard heaters thermostat

How To Install Nest/Ecobee With Electric Baseboard Heaters

Second, if you have two or more baseboard heaters in the same room, you have to adjust each of them individually. It is much more convenient and efficient to connect the baseboard heaters in parallel and hook them up to one wall-mounted, across-the-line thermostat. Locate a spot on a wall opposite the baseboard heaters to mount the thermostat.


  1. nettsteder for dating.
  2. 18 Comments.
  3. dating website birmingham?
  4. up hook up com;
  5. dating hotlines free.
  6. dating simulation games for android.

Measure and mark a spot 5 feet up from the floor. Use an electronic stud finder to make sure that you will not be drilling or cutting into a wall stud.

How to Install a Baseboard Heater Thermostat | www.hiphopenation.com

Draw an outline around it. Drill into the wall space where the thermostat cutout is located. Turn off the branch circuit breaker at the power panel and disconnect the power from the first baseboard heater in the circuit. Reroute the power cable from the baseboard heater to the wall cutout where the thermostat will be located. Remove 6 inches of the outer jacket from both cables and insert them into the thermostat box. Push the box into the wall cutout and use a screwdriver to turn the screws to secure the box to the wall.

As you turn the screws clockwise, the mounting wings will be drawn up against the backside of the wall, holding it in place.

Remove 1 inch of insulation from the ends of the individual wires. Reidentify the white wires as current-carrying wires by wrapping their exposed insulation with black electrical tape. Connect the two bare ground wires together using a wire nut. Install the thermostat in its box.


  • hookup site profiles.
  • serbian dating site toronto.
  • How to Hook Up Two Baseboard Heaters to One Thermostat!
  • Reidentify the white wire at the heater connections box. Connect the insulated wires bringing power to the heater to the red and black heater wires. Make these splices three-way splices by connecting the wires carrying the power to the second heater to them.

    How to Install a Baseboard Heater Thermostat

    So a volt circuit running on a amp, double-pole breaker, can have any combination of heaters up to 3, watts. All heaters must be wired in parallel. You can also check out the wiring diagram at the top of this post — it shows how to wire multiple baseboards together. Skip to content Search for: For example, using just one thermostat, you can install: Two 1, watt heaters, or Three 1, watt heaters, or Five watt heaters This helpful chart provides more information.

    This photo shows how you would connect wires to use multiple Com-Pak heaters to each other.